Shop

<< Back

Axle Repair

9133
9133 Usage

9133 Pilot Bearing Separator (Screw type)

image_pdfimage_print
  • Removes fly wheel pilot bearings and bushings up to 7-1/2″ / 19cm long
  • Better than slide-hammer type when working in tight areas
  • Better control for precision pulling
  • Jaws: 8070×06 – Standard Range – 1/2 to 1-1/2″ (13 to 38mm I.D.)
  • Made In Taiwan

INSTRUCTIONS:

1. Remove transmission, bell housing, clutch pressure plate and disc.
2. Back out the bearing puller drive screw so that the jaws close.
3. Insert the jaws through the center hole in transmission pilot bearing in the crankshaft, then turn drive screw clockwise to spread the jaws tight against the inside of the bearing.
4. Hold the tool’s drive screw handle and use a wrench to tighten the nut until the pilot bearing is pulled from the crankshaft.